DIRECTIONS

NOTE:  Please refer to the PDF for pictures #1-16.

1. For the wire you want for the rose, cut 18 inches and straighten it with the nylon jaw pliers.

2. Using the ring sizer, place the center of the wire on your ring size and wrap each end once around the sizer. (pic. 1)

3. Double check that you’re still on your ring size and then twist the wire together once. (pic. 2)

4. Pull the wire, starting with the right side, go under the left wire while folding it inward one at a time under each other. (pic. 3 - pic. 9)

5. Repeat the last step by following around over and over to build your flower until you get to the end. (pic. 10)

6. When you reach the end, take what’s left of one wire and thread it through the groove of the ring sizer and wrap around the ring base on either side of the rose.  Repeat with the other wire end (pic. 11) but wrap on the opposite side of the rose.

7. For the wire you want for the leaf, cut 3 inches. (pic. 13)

8. Thread the wire under the rose and wrap aroundthe side (pic. 14)

9. Coil end and then bend with chain nose pliers.

10. Pinch to make the point of the leaf. (pic. 15)

11. Repeat with the other end of the wire.

12. Pinch under the ring to tighten the leaf wire to the ring (pic. 16)

13. Return the ring to the ring sizer to tighten and reshape.