Panda Fan

Click here to download project sheet.

MATERIALS

MATERIALS:

  • 1 qty. Pre-Made Paper Fan - white edge #30139464
  • 1 qty. 4.25"x11" Black Cardstock (ears, eyes, and nose)
  • 1 qty. 3"x4" White Cardstock (eyes)
  • 18"x5/8" Sheer Ribbon - bow
  • Meriken 1/4" Double Stick Tape #30013284
  • Mini Glue Dots #30013284

TOOLS:

  • Sharp Scissors
  • Marvy Uchida Clever Lever Punch - 1" Circle (green) #30028719
  • Marvy Uchida Clever Lever Punch - 1.5" Circle (yellow) #30028731
  • Marvy Uchida Clever Lever Punch - 3" Oval (purple) #30028763
  • EK Success Punch - 3/8" Circle #30136619

DIRECTIONS

Take the 3" punch and punch out 4 pieces from the black yardstick. Set aside.

EYES:

1.  Take the white yardstick and use the 1" circle punch to punch out one circle.  Next take the 1.5" circle punch, turn it upside down so you can see where you would be punching.  Place over the 1" circle hole, centered and towards one side; punch.  This is for one eye.  Repeat steps to make the other eye.

2.  Refer to the pictured sample for reference.  Take two of the 3" black ovals and place on the center of the fan at a slight angle for the eyes; tape in place.  Place one white cardstock eye piece onto each towards the top ends and tape in place.  Punch out two 3/8" circles from the scrap white yardstick.  Place one in the center of the 1" black circle of each eye and glue dot in place.

3.  Take the remaining black yardstick and punch out 1" circle.  Place below the eyes and tape in place for the nose.

4.  Take the remaining two black 3" oval and place one each behind the top of the fan for the ears; tape in place.

FINISHING:

Make a loopy bow with the sheer ribbon and tie to the fan handle.